Two digitally controlled preamps provide individually switchable 48V phantom power. Full range capture - Improved Mic & Line Inputsįor the main I/O RME have designed a XLR socket, which integrates seamlessly into the housing and saves space. Finally the output impedance of 3.5 mm TRS was lowered from 2 Ohms to 0.1 Ohms. and uses same output op-amps as ADI-2 Pro now. THD of both phones outputs improved by up to 10 dB. The 3.5 mm TRS phones output power rises to 90 mW. The two headphone outputs, offering TRS and mini-jack sockets in parallel, have completely separate driver stages to perfectly match low and high impedance headphones, guaranteeing pristine sonic results no matter what type of headphone is used. All the above improvements were achieved without raising the units power consumption.6 samples less latency on the AD side by new ADC (5 samples AD, 7 samples DA.Mic inputs SNR improved from 112.2 dB to 113.7 dB, TRS Line inputs SNR improved from 114 dB to 116.3 dB (120 dBA).Output impedance of 3.5 mm TRS lowered from 2 Ohms to 0.1 Ohms. Uses same output op-amps as ADI-2 Pro now. 3.5 mm TRS phones output power rises from 70 mW to 90 mW.Full Stead圜lock FS circuit as in the ADI-2 Pro FS for lowest jitter and highest jitter immunity.+19 / +4 dBu switch on the bottom adds a direct way to reduce the output level, thus improves SNR for sensitive active monitors, avoids distortion / overload, and helps to keep TotalMix FX faders near 0 dB instead of high attenuations.In the new Babyface Pro FS even more improvements were implemented: Its innovative energy saving technologies provided supreme fidelity with no compromises in level, noise or distortion. Created with the highest precision from a block of aluminum, this high-end portable interface incorporated newly designed analog and digital circuits. Four years ago the Babyface Pro again demonstrated RME’s absolute commitment to superior craftsmanship, not only in audio circuits and driver development, but also in mechanics.
0 Comments
Leave a Reply. |